bms/Application/app/pcba_test.c

#include "bsp/gpio.h"
#include "bsp/ml5238.h"
#include "bsp/uart.h"
#include "bsp/gd32_adc.h"
#include "nv_storage.h"
#include "pcba_test.h"

int pcba_test(uint8_t *data, int len, uint8_t *response){
	uint8_t *payload = data + 2;
	int resp_len = 0;
	response[resp_len ++] = 0xFE;
	response[resp_len ++] = 0xFE;
	response[resp_len ++] = 0; //len
	response[resp_len ++] = payload[0];
	response[resp_len ++] = payload[1];
	uint8_t cmd = payload[1];
	if (cmd == 0x00) {
		response[resp_len ++] = ml5238_noop_register_rw(payload[2]);
	}else if (cmd == 0x01) {
		response[resp_len ++] = (uint8_t)nv_read_write_test();
	}else if (cmd == 0x02){
		int8_t temp;
		uint8_t result = 0;
		for (int i = 0; i < PACK_TEMPS_NUM; i++){
			temp = get_pack_temperature(i);
			if(!(((temp >= 24) && (temp <= 26))||((temp >= 63) && (temp <= 67)))){
				result = 1;
			}
		}
		response[resp_len ++] = result;
	}else if (cmd == 0x03) {
		response[resp_len ++] = 0;
	}else if (cmd == 0x04) {
		LED1_ON(0);
		LED3_ON(0);
		LED0_ON(1);
		LED2_ON(1);
		LED4_ON(1);
		response[resp_len ++] = 0;
	}else if (cmd == 0x05) {
		LED0_ON(0);
		LED2_ON(0);
		LED4_ON(0);		
		LED1_ON(1);
		LED3_ON(1);
		response[resp_len ++] = 0;
	}else if (cmd == 0x06) {
		LED1_ON(0);
		LED3_ON(0);
		charger_open(0);
		discharger_open(0);
		start_aux_power(0);
		response[resp_len ++] = 0;
	}else if (cmd == 0x07) {
		start_aux_power(1);
		response[resp_len ++] = 0;
	}else if (cmd == 0x08) {
		response[resp_len ++] = io_state()->aux_lock_detect;
	}else if (cmd == 0x09) {
		start_aux_power(0);
		response[resp_len ++] = 0;
	}else if (cmd == 0x0a) {
		ml5238_enable_load_detect(1);
		delay_us(1000);
		response[resp_len ++] = !ml5238_is_load_disconnect();
	}else if (cmd == 0xb) {
		charger_open(0);
		discharger_open(0);
		start_aux_power(0);
		delay_us(1000);
		response[resp_len ++] = io_state()->charger_detect_irq;
	}else if (cmd == 0xc) {
		charger_open(0);
		discharger_open(0);
		start_aux_power(0);
		response[resp_len ++] = IS_CHARGER_IN();
	}else if (cmd == 0xd) {
		response[resp_len ++] = io_state()->aux_lock_detect;
	}else if (cmd == 0xe) {
		charger_open(0);
		discharger_open(0);
		start_aux_power(1);
		response[resp_len ++] = 0;
	}else if (cmd == 0xf){
		response[resp_len ++] = !IS_HALL1_DETECTED();
		response[resp_len ++] = !IS_HALL2_DETECTED();
	}else if (cmd == 0x10) {
		if (payload[2] >= 3) {
			charger_open(1);
			discharger_open(1);
		}else if (payload[2] == 1){
			charger_open(0);
			discharger_open(1);
		}else{
			charger_open(1);
			discharger_open(0);
		}
		response[resp_len ++] = 0;
	}else if (cmd == 0x11) {
		response[resp_len ++] = ml5238_is_discharging() | ml5238_is_charging()<<1;
	}else if (cmd == 0x22) {
		uint16_t health = *(uint16_t *)bms_health();
		response[resp_len ++] = AUX_VOL_IS_OPEN();
		response[resp_len ++] = health;
		response[resp_len ++] = health >> 8;
	}else if (cmd == 0xa1) {
		charger_open(0);
		discharger_open(0);
		start_aux_power(0);
		response[resp_len ++] = 0;
	}else if (cmd == 0x12) {
		uint16_t aux_power_adc = (uint16_t)adc_sample_avg(ADC_CHAN_AUX_CURR, 10);
		response[resp_len ++] = aux_power_adc;
		response[resp_len ++] = aux_power_adc >> 8;		
	}else if (cmd == 0x13) {
		shark_uart_deinit(SHARK_UART1);
		rcu_periph_clock_enable(RCU_GPIOA);
		gpio_mode_output(GPIOA, GPIO_PUPD_NONE, GPIO_OTYPE_PP, GPIO_OSPEED_10MHZ, GPIO_PIN_2);
		gpio_mode_input(GPIOA, GPIO_PUPD_NONE, GPIO_PIN_3);
		gpio_bit_set(GPIOA, GPIO_PIN_2);
		response[resp_len ++] = gpio_input_bit_get(GPIOA, GPIO_PIN_3);
	}else if (cmd == 0x16) {
		gpio_bit_reset(GPIOA, GPIO_PIN_2);
		response[resp_len ++] = gpio_input_bit_get(GPIOA, GPIO_PIN_3);
	}else if (cmd == 0x14) {
		UART0_IR_EN(0);
		response[resp_len ++] = gpio_output_bit_get(GPIOC,GPIO_PIN_14);
	}else if (cmd == 0x15) {
		UART1_IR_EN(0);
		response[resp_len ++] = gpio_output_bit_get(GPIOF,GPIO_PIN_0);
	}else if (cmd == 0x17) {
		uint16_t vol = 0;
		for (int i = 0; i < CELLS_NUM; i++){
			if (measure_value()->cell_vol[i] > 3000 && measure_value()->cell_vol[i] < 3400) {
				vol = measure_value()->cell_vol[i];
				break;
			}
		}
		response[resp_len ++] = vol;
		response[resp_len ++] = vol >> 8;	
	}else if (cmd == 0x18) {
		uint8_t result = 1;
		if (payload[2] == 1) {
			charger_open(1);
			discharger_open(1);
			result = 0;
		}else if (payload[2] == 2){
			if (measure_value()->load_current >= -5300 && measure_value()->load_current <= -4700){
				result = 0;
			}
		}else if (payload[2] == 3) {
			if (io_state()->aux_lock_detect) {
				result = 0;
			}
		}else if (payload[2] == 4) {
			charger_open(0);
			discharger_open(0);
			result = 0;			
		}
		response[resp_len ++] = result;
	}
	response[2] = resp_len;

	return resp_len;
}